39
However, Windows NT will not use the boot order set by the SCSI Configuration Utility.
Windows NT always finds PCI bus 0 first. Ensure that your system’s primary boot device is
on PCI bus 0, and then use the SCSI Configuration Utility as needed to change boot order.
Assigning System Resources
Some expansion cards include a configuration diskette that you can use to reserve the system
resources required for the card. Other expansion cards do not include a diskette, but require
that you manually program the BIOS with the configuration information.
See the System Setup for details on assigning system resources and configuring the BIOS for
expansion cards, a list of available system address resources (DMA, I/O, memory), and related
details.
NOTE
Treat non-compliant PCI cards and PCMCIA cards as ISA cards for assigning system
resources.
Adding Internal SCSI Drives
The system features integrated Narrow Ultra SCSI and Wide Ultra2 SCSI adapters, both with
internal and external ports, to support internal and external mass storage devices.
The TDZ 2000 GT1 features the following peripheral bays:
One 3.5-inch x 1.0-inch external bay for floppy or combo drive.
One 5.25-inch x 1.6-inch external bay for CD-ROM.
Two 5.25-inch x 1.6-inch external bays for disk drives or other devices.
Three 3.5-inch x 1.0-inch or two 3.5-inch x 1.6-inch internal bays for system or optional
disks.
See the following chapters for related information and important details:
Chapter 5, “System Board,” for details on SCSI connector locations and pinouts.
Chapter 6, “Peripherals,” for details on drive locations, jumpers, and cables.
Chapter 7, “Power Supply and Cooling Fans,” for details on power supply cable
connectors and pinouts.
Remember the following when installing devices in the system’s drive bays:
If you are installing a SCSI drive, have the vendor’s documentation available to follow
instructions for setting the SCSI ID, enabling or disabling termination, installing device
drivers when required, and configuring other drive attributes.
