19
9. Insert the alignment tabs into the appropriate slots in the chassis.
Screw holes for front mounting tabs
10. Install the two screws that secure the drive bracket assembly front mounting tabs to the
chassis.
11. Install the screw that secures the drive bracket assembly to the right side of the chassis.
12. Install the right side panel.
13. Connect the SCSI cable and the power cable to the new drive.
External SCSI Terminator
The connector for the external SCSI terminator board (MSMT283) is mounted on the rear of
the chassis just below the lower chassis fan. The external SCSI terminator provides active
termination for the system end of the external Narrow Ultra SCSI bus. Cable MCBL387
connects the terminator to J41 on the system board. See the system board diagram in Chapter
5, “System Board,” for connector and socket locations.
To replace the external Ultra SCSI terminator board:
1. Swing the power supply out of the chassis. See Chapter 1, “Accessing the System,” for
details.
2. Unfasten the reusable wire tie that secures the power supply cable bundle.
3. Lift the power supply off its hinge pins and place it aside carefully.
4. Disconnect the SCSI cable from the terminator board. See the following figure.
