20
SCSI cable (to J44)
Screws (2)
Terminator board
5. Remove the two small screws that secure the connector to the rear of the chassis.
6. Note the orientation of the terminator board and remove it from inside the chassis.
7. Orient the new terminator board component side down, align the mounting holes of the
new terminator with the chassis mounting holes, and install the two screws.
8. Connect the SCSI cable to the terminator.
9. Place the power supply on its hinge pins and fasten the wire tie on the cable bundle.
10. Swing the power supply back into the chassis and secure it with the plungers.
Power Supply
See Chapter 7, “Power Supply and Cooling Fans,” for details on the power supply.
To replace the power supply:
1. Unplug the AC power cord from the rear of the unit.
2. Note the location of all power cable connectors on the system board and peripheral
devices.
3. Disconnect all power cables from all internal devices and the system board.
4. Place the power supply cable bundle outside the chassis.
