Optional Interaction Edge configuration
31
Tip:
Select the
Cancel
button at the bottom of the page to discard any changes you made since
you last selected the
Apply
button.
Change diagnostic port (IPMI) network settings
1.
On a computer, open a web browser and navigate to the IP address of the Interaction Edge appliance.
Note:
The default HTTPS port number for Interaction Edge is 443.
2.
When prompted, supply the administrator credentials and select the
Log in
button.
The
Status-System
page of the Interaction Edge interface is displayed.
3.
In the upper right corner of the page, select the
Settings
icon.
The
Settings-System
page is displayed.
4.
In the
Diagnostic Port Settings
area, make the necessary configuration changes.
Note:
You can find descriptions of each control and its settings in
Interaction Edge Help
. Select the
Help
icon in the upper right corner of the page.
5.
After you have made the necessary changes, select the
Apply
button at the bottom of the page.
Interaction Edge saves your changes to the configuration.
Tip:
Select the
Cancel
button at the bottom of the page to discard any changes you made since
you last selected the
Apply
button.
Configure SNMP
1.
On a computer, open a web browser and navigate to the IP address of the Interaction Edge appliance.
Note:
The default HTTPS port number for Interaction Edge is 443.
2.
When prompted, supply the administrator credentials and select the
Log in
button.
The
Status-System
page of the Interaction Edge interface is displayed.
3.
In the upper right corner of the page, select the
Settings
icon.
The
Settings-System
page is displayed.
4.
On the left side of the page, select the
Snmp
tab.
The
Settings-Snmp
page is displayed.
5.
Make the necessary configuration changes.
