5
3. THREAD BREAK DETECTOR
Position the thread break detector on the top of the arm, so the hole in the bracket
is about 7" (178mm) from the rear edge of the head and the whole adhesive pad is
beyond the separation line (see Fig. 5). Mark the position of the edge of the bracket.
Fig. 5
Clean the surface where the bracket will be placed with alcohol.
Remove the clear protective foil from the double-sided tape on the bracket and push
it firmly to the surface, making sure that it sticks only to the left side of the body
(viewed from the front). Set the wheel position so it is aligned with the thread path.
Note the proper threading direction: it should be wrapped around the wheel
clockwise.
Содержание HQ-AVANTE 03.25.16
Страница 17: ...17 Fig 17 ...
Страница 18: ...18 Mount the power supply on one of the middle legs of the table using 14 wire ties as Fig 18 shows Fig 18 ...
Страница 19: ...19 Tie the cables to the posts on both motors as Fig 19 shows Fig 19 ...
Страница 22: ...22 COPY THE LOGS AND POST THE logs tar gz FILE TO THE SUPPORT PAGE OF www intelliquilter com ...
