Platform Setup
Dual-Core Intel® Xeon® Processor LV and Intel
®
3100 Chipset
User’s Manual
January 2007
28
Order Number:315879-002
2.1.1
Connect SATA cables
1. There are six SATA (Serial ATA
Figure 15
) connectors on the CRB. Connect the
cables to the appropriate drive sequentially starting from connector Port SATA 0
through connector Port SATA 5. These connectors are located in coordinate E4.
P
Note:
Intel recommends that your boot drive be connected to SATA Port 0.
2.1.2
Plugging In Memory
Note:
Refer to section
Section 1.3
for memory specific information refer to
Figure 16
for
DIMM location while reading below steps.
1. Beginning with DIMM 3, (the DIMM connector closest to the edge of the CRB,
furthest from Intel
®
3100 Chipset) line up the DIMM with the slot and make sure
that the end clips are moved outward to the open position.
2. Gently push the DIMM into the socket until you hear or feel the side clips lock into
the side of the DIMMs.
3. Continue adding memory to the system sequentially starting from DIMM 3to DIMM
0.
Note:
The specific DIMM configurations are found in
Section 1.3.2
.
Figure 15.
SATA Ports
