Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, Руководство пользователя

Страница: 72 / 184

50 Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
Note: For proper airflow, the hard drive carrier must be replaced in the server system, even if no
hard drive is installed in it.
8. When the black lever begins to close by itself, push on it to lock the drive carrier
into place.
9. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
10. (Optional) Install the front bezel. For instructions, see “Installing the Front Bezel” .
11. Plug all peripheral devices and the AC power cable(s) into the server.
Installing or Removing a Slimline Optical Drive
(SR1530AH / SR1530AHLX)
Caution: The optical drive is NOT hot swappable. Before removing or replacing the optical drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
Installing a Slimline Optical Drive
Notes:
•
If you are replacing an optical drive, see “Removing a Slimline Optical Drive” on
page 54 for instructions first. Return to these steps when directed.
•
The hardware necessary to install your optical drive was shipped to you in a bag
labeled “CD-ROM Assy”.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover” on page 28 .
4. Remove the bezel if it is installed. For instructions, see “Removing the Front
Bezel” on page 26 .
5. Note the orientation of the PCI cooling fan that is located behind the optical drive
bay, then lift the fan from the mounting pegs. It is not necessary to disconnect the
fan cable. See letter “A” in
Figure 42 .