Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, Руководство пользователя

Страница: 50 / 184

28 Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
Removing and Installing the Server Cover
Removing the Server System Cover
The server system must be operated with the server system cover in place to ensure proper
cooling. You will need to remove the cover to add or replace components inside of the
server.
None of the internal components are hot-swappable. Before removing the server system
cover, power down the server and unplug all peripheral devices and the AC power cable.
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” on page iii .
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the AC power cord.
4. SR1530AH/SR1530AHLX: Remove the two screws at the front of the chassis. See
letter “A” in the figure below.
5. SR1530AH/SR1530AHLX: Loosen the screw at the rear of the chassis. See letter
“B” in the figure below.
6. SR1530AH/SR1530AHLX: Push rearward on the blue grip point at the front of the
server. Slide the cover back until it stops and then lift the cover upward to remove
it. See letter “C”.
Figure 16. Removing the Server System Cover (SR1530AH/SR1530AHLX)
B
C
A
AF000662