Intel SR1530 - AHJPCIERISER PCI-E x8 Riser Card, Руководство пользователя

Страница: 71 / 184

Intel
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX 49
10. With the black lever in the fully open position, slide the drive assembly into the
server system (see letter “A” in Figure 41 ). The green latch at the front of the drive
carrier must be to the right. Do not push on the black drive carrier lever until the
lever begins to close by itself.
11. When the black drive carrier lever begins to close by itself, push on it to lock the
drive assembly into place (see letter “B” in Figure 41 ).
Figure 41. Install Drive Assemby into the Server System (SR1530HAHLX)
12. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
13. (Optional) Install the front bezel. For instructions, see “Installing the Front Bezel” .
14. Plug all peripheral devices and the AC power cable(s) into the server.
Removing a Hot-Swap SATA Drive (SR1530HAHLX)
1. Remove the front bezel if it is installed. For instructions, see “Removing the Front
Bezel” .
2. Press in on the green latch at the front of the hard drive carrier.
3. Pull out on the black lever to slide the carrier from the server system.
4. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier. Store the drive in an anti-static bag.
5. If you are not installing a new drive, place the plastic retention device into the drive
carrier, using the four screws you removed from the hard drive.
6. Insert the screws that held the drive in the carrier into the screw locations on the
carrier for future use.
7. With the black lever in the fully open position, slide the drive carrier into the server
system. The green latch must be to the right. Do not push on the black lever until
the lever begins to close by itself.
A
B
AF0015 8 5