Intel Express 510T, Руководство пользователя

Страница: 30 / 126

681872.bok : 68187201 20 Mon Apr 20 15:35:05 1998
Express 510T Switch
Recovering from Start-up Failure
20
1
Commands allowed in
Maintenance Mode
The following command is available for the switch in Maintenance
Mode:
bootptab file entry
The entry for the switch in the
bootptab
should contain a line simi-
lar to:
:bf=/intel/switch/es510T_x.xx:
This will instruct the switch to load the switch software from the
bootp/tftp server. You should use the Intel Device View application
to configure the switch manually, or transfer the inxxxxxx.p file con-
taining the configuration from a TFTP server to the switch.
Command Use
TFTP <filename> ownIP tftpIP [gwIP]
To load software using the TFTP protocol
<filename>
: the name of the file containing
the software
ownIP
: your own IP address
tftpIP
: the IP address of the TFTP host
[gwIP:
the IP address of the primary router
(intermediate gateway)— required if the TFTP
server is located on a remote part of the network
BOOTP <filename>
To load software using the BOOTP or TFTP
protocol
<filename>
: the name of the file containing
the software
DUMP addr
Dump memory contents
INFO
Show hardware information
RESET
Resets the switch
RUN defparm
Starts the software in it’s default factory settings