Intel Express 510T, Руководство пользователя

Страница: 20 / 126

681872.bok : 68187201 10 Mon Apr 20 15:35:05 1998
Express 510T Switch
Installation
10
1
Installing a module
To install a module:
1 If the switch is already operational, disconnect it from the main
power supply.
2
Follow the instructions in “Avoiding damage to the circuit
board” above.
3
Unscrew the screws of the plate covering the slot on the front of
the switch. Save these screws and plate.
4
Insert the module into the slot. Place your thumbs just beneath
the screws on the front plate of the module and push the module
in until it clicks into position. Secure it using the retaining
screws.
Note
If the module does not click into position, refer to the
Intel Support Web Page (http://support.intel.com) for
full instructions on how to install the module success-
fully.
Removing the module
To remove a module:
1
If the switch is already operational, disconnect it from the main
power supply.
2
Follow the instructions in “Avoiding damage to the circuit
board” above.
3
Unscrew the screws securing the module.
4 Pull the module gently to disengage the connectors fully from
the socket on the motherboard. Slide the module out com-
pletely.
5 Cover the empty module port with the plate and secure using
the screws.
Connecting Other Devices
Introduction
Incorrect cabling is often the cause of network configuration prob-
lems.
Use shielded cables
Shielded cables normally comply with EMC and FCC emission lim-
its.