3
IN-P
Multifunction Process
Indicator.
Product Liability.
This information describes our products. It does not constitute guaranteed properties and is not intended to affirm the
suitability of a product for a particular application. Due to ongoing research and development, designs, specifications, and documentation are subject
to change
without notification. Regrettably, omissions and exceptions cannot be completely ruled out. No liability will be accepted for errors, omissions or
amendments to this specification. Technical data are always specified by their average values and are based on Standard Calibration Units at 25C,
unless otherwise specified. Each product is subject to the ‘Conditions of Sale’.
Warning: These products are not designed for use in, and should not be used for patient connected applications. In any critical installation
SECTION 1. –
Description.
Ordering Information.
www.intech.co.nz
Functions available on request:
ITEMS
CODE
DESCRIPTION
SERIES
IN-P-
Multifunction Process Indicator
ANALOGUE
INPUTS
PRC1-
1x 4~20mA / 0~10V input + 24Vdc excitation
PRC4-
4x 4~20mA input + 24Vdc excitation
TC1-
1x Thermocouple input
Types B, J, K, N, R, S, T
TC4-
4x Thermocouple input
Types B, J, K, N, R, S, T
RTD1-
1x RTD Pt100 input
RTD4-
4x RTD Pt100 input
RELAY OUTPUTS
N-
None
R2-
2x 5A relay outputs *
For PRC1 model only
R4-
4x 5A relay outputs
R6-
6x 5A relay outputs *
For PRC1 model only
ANALOGUE OUTPUT / RETRANSMISSION
N-
None
A-
1 x 4~20mA / 0~10V Analogue Output
COMMUNICATIONS
* Not all Communication options are available for each input
model type, confirm with Intech.
N-
None
WS232-
1x serial port Isolated RS232
WS485-
1x serial port Isolated RS485
WEA-
With an Ethernet port (Ascii)
WEM-
With an Ethernet port (Modbus)
POWER SUPPLY
HV- 85~265Vac / 95~370Vdc
LV- 15~48Vac / 10~72Vdc
The IN-P Multifunction Process Indicator interfaces smoothly with a
wide range of PLC and monitoring systems. Designed specifically for
use in process applications, this indicator accepts a variety of inputs.
The IN-P can be configured for many different analogue inputs and
functions as listed below.
Setup and calibration is simple, with on-screen, step-by-step
instructions. The IN-P has a 6-digit LED display, 6 set-points and
5 front panel buttons for easy setup and operator interface.
Up to 6 relay outputs, an analogue output and/or communications can
also be added.
- Auto or manual scanner with alarms.
- Maths functions, (i) √, (ii) Difference, (iii) Average, (iv) Hi / Lo Select.
- Hold, Tare, Reset (External switches connect to rear terminals).
- Flow Rate + Totalising.
- Energy display & totaliser (flow x ∆T).
- Step controller.
- Auto / Manual Station.
- Retransmission.
- Other Functions – please specify.
- Data Logging.
A
B
C*
D*
E*
F
G*
H
I
J
* Available on channel one only.
Ordering Example:
IN-P-RTD4-R2-N-WS485-HV
Multifunction Process Indicator; 4x RTD Pt100 Inputs,
2x 5A relay outputs, 1x serial port RS485,
85~265Vac / 95~370Vdc Power Supply.
(was IN-P4)
