11
SECTION 9. –
Reset PIN Numbers.
If you have forgotten either of your PIN numbers, follow the procedure below to reset both the calibration and setpoint
entry PIN’s to their factory default of 1.
A
Press the
,
and
P
buttons at the same time.
(This key combination can be difficult to execute and you may need several attempts to get it right.)
B
When successful, a factory identification text will scroll across the display, followed by:
_ _ _ ALL PIN NUMBERS RESET TO 1
.
C
Reset the PIN numbers individually as required by following the instructions in Sections 6.7 and 7.3, entering ‘1’
whenever you are prompted for your current PIN.
SECTION 10. –
Display Brightness.
To adjust the brightness of the LED display:
A
Press the
P
and
buttons together from the operational display.
BRI
appears on the screen and toggles with the
current brightness setting.
B
Use the
and
buttons to adjust the brightness of the LED backlight as required, and then press
P
.
The display returns to normal operating mode.
SECTION 11. –
Display Shortcuts.
Use these shortcuts for quick viewing of specified parameters from the operational display:
To view the maximum (peak) value:
Press the
button for ½ a second. The word
PEAK
appears on the display
and toggles with the maximum measured process input value.
Press
P
to return to the operational display.
To view the minimum (valley) value:
Press the
button for ½ a second. The word
VALLEY
appears on the
display and toggles with the minimum measured process input value.
Press
P
to return to the operational display.
To reset peak or valley:
Press both the
and
buttons together while the required parameter is
being displayed.
7.3
–
Edit setpoint PIN:
A
_ _ _ EDIT SP PIN NUMBER?
scrolls across the display and toggles with
SKIP
.
Press
P
to skip and return to the operational display, or the
button and then
P
to
ENTER
.
B
_ _ _ ENTER NEW SP PIN NUMBER
scrolls across the display and toggles with the current PIN (default = 1).
Using the
and
buttons, enter your new totalizer reset and setpoint entry PIN number.
Then press
P
to
EXIT
and return to the operational display.
SECTION 8. –
Setpoint Direct Access.
If none of the setpoints have their direct access option enabled then the
F2
button will not respond to a short press.
(See 7.2G to enable.)
8.1
–
Setpoint direct access:
A
Begin by pressing the
F2
button for half a second. The name of the first access-enabled setpoint
(
SP 1
,
SP 2
,
SP 3
,
SP 4
,
SP 5
or
SP 6
) will appear on the display and toggle with the current value for that
setpoint.
Using the
and
buttons, adjust the selected value.
Then press
P
to accept and progress to the next access-enabled setpoint.
SP3-4 are not available for models with only two relays installed.
B
Pressing
P
for the last access-enabled setpoint will exit and return to the operational display.
