Intec ColorCut BC480, Руководство пользователя

Страница: 9 / 29

Page 14 Page 15
• Close to heating and cooling sources
• Vibration of work surface
!
Attention
• Don’t put any other electrical plug, other than what has been provided, into electrical outlet
• Prone to static - you should use static shield and humidifier
• Don’t put the machine on a table that is smaller than its footprint
2. Operation
2-1 Cutting workflow
This flowchart shows you the process for machine usage.
2-2 Operation panel description
LCD display description
Initial understanding of the LCD panel is important. Please take a little time to navigate yourself
through the buttons and display before completing any work.
!
When the BC480 is turned on it will go into the last mode used.
With the BC480 turned on and in standby press the
MODE
SET
button. This will change your cutting
Mode number (0-9). The cutting mode is the preset COLUMN width size in mm and is defined by the
cassette delivered with the BC480 and ROW length - this figure is variable and dependant on the
card size you would like to cut.
Press this button to understand how the modes change and watch the card sizes change - this does
not change your sheet / paper size. The modes are explained in Section 2-4.
After pressing through the modes now press the
MODE
SET
for 3 seconds. This will take you into the
setup menu as shown below: