MoRoS ADSL 2.1 PRO
Functions
13.2.9
Creating or Deleting a Port Forwarding Rule
If port forwarding is enabled, the router forwards packets coming in from the WAN
to the machines in the LAN, which have been specified in the port forwarding
rules.
Only the WAN IP address of the MoRoS ADSL 2.1 PRO is accessible from the
WAN, if NAT is enabled for packets going into the WAN. The local terminal devices
in the network of the device can still be accessed with this IP address using port
forwarding. Packets from the WAN sent to the WAN IP address at a port x, can be
forwarded to a machine with the IP address Y at the port y.
Configuration via the web interface
In order to enable port forwarding, check in the menu "LAN (ext)" on the
page "Port forwarding" the checkbox "Activate port forwarding for LAN
(ext) interface".
In order to create a port forwarding rule, select in the field "Create new
rule" the protocol and specify the port range, for the incoming packets at
the MoRoS ADSL 2.1 PRO. Enter an IP address for the routing
destination in the entry field "to IP address" and a port in the entry field
"to port"; this is the address and the port where the packets are routed
to.
In order to disable an existing rule, disable the checkbox "active" of the
respective rule and then click on "OK".
In order to delete an existing rule, check the checkbox "delete" of the
respective rule and then click on "OK".
The rules in the list are processed from top to bottom. If two rules
contradict each other (for example, the same port is used twice), only the
rule which is further up in the list will be processed.
55
