Assembly
MoRoS ADSL 2.1 PRO
10
Assembly
This section describes how to mount the MoRoS ADSL 2.1 PRO to a DIN rail,
connect the power supply and uninstall it again. Observe the instructions in
the "Safety" section of this manual, in particular the "Safety Instructions for
Electrical Installation" for that purpose unconditionally.
Caution!
Moisture and liquids from the environment may seep into
the interior of the device!
Fire hazard and damage of the product.
The device must not be used in wet or damp environments,
or in the direct vicinity of water. Install the device at a dry
location, protected from water spray. Disconnect the power
supply before you perform any work on a device which
may have been in contact with moisture.
Caution!
The device could be destroyed if the wrong power supply is
used!
If the device is operated with a power supply that supplies
a voltage exceeding the permissible operating voltage, it
will be destroyed.
Make sure that you use the suitable power supply. Refer to
the Technical Data section for the proper voltage range.
34