MoRoS ADSL 2.1 PRO
Functions
In order to configure a default route, check in the menu "LAN (ext)" on
the page "Routing" the checkbox "Set default route to gateway". The
device cannot switch the data traffic between the internal network at the
switch and the ADSL connection without the default route to the internal
ADSL modem.
Save your settings by clicking "OK".
13.2.3
Configuring Leased Line Operation
You can configure the MoRoS ADSL 2.1 PRO to permanently maintain the
previously configured DSL connection. The connection will immediately be
established the connection after system start in this operating mode. The device
checks the connection for its function periodically. The connection check can be
performed either via a DNS request of a host name or via PING at a host.
Configuration via the web interface
In order to configure a leased line, check in the menu "LAN (ext)" on the
page "DSL" the checkbox "Connect immediately and hold connection".
If necessary, enter another time in minutes for the connection check into
the entry field "Interval for checking connection". The default setting is 5
minutes. If a closed connection is determined after this time, the MoRoS
ADSL 2.1 PRO will attempt to re-establish the connection after one
minute. If the attempt fails, there will be another attempt after 5 minutes.
The next attempt will take place after 30 minutes; if this attempt fails as
well, the device will attempt to re-establish the connection every 60
minutes.
Select the method for connection check using the radio buttons behind
"Type to check the connection" and enter a host name or an "IP
address". If the checkbox "Renegotiate PPP connection in case of failure"
is checked, a failed ping or DNS request causes that a possibly existing
connection will be closed. It will be attempted to establish a connection
again afterwards in any case.
Save your settings by clicking "OK".
This function is only effective, if the LAN ext interface is configured for
a PPPoE connection.
49