MLR 3G 2.0
Functions
10.1.2
Setting IP Addresses
It must be possible to access the MLR 3G 2.0 in the LAN under a certain IP address. You
must assign a static IP address for this.
A virtual network address can be assigned to the local network. Devices in the local net-
work can then be addresses with the virtual address via WAN. The MLR 3G 2.0 replaces
the network portion of the virtual IP address with the network portion of the local net-
work and forwards the packet to the destination.
Configuration with the web interface
In order to configure a
static IP address
, change in the "Basic Settings" menu
to the "IP address (LAN)" page.
Enter
the
IP address
of the MLR 3G 2.0 in the LAN into the entry field "IP ad-
dress" and the
Subnet mask
into the field "Netmask address".
When changing the local IP address, the address range of the DHCP server
will be adjusted to the new network automatically, if the netmask has not
changed. The DHCP server will be disabled with a changed netmask and
must be configured manually. This is indicated in a notification.
The
MAC address of the MLR 3G 2.0
can be found in the entry fields for the IP
address and the network mask under "MAC address" on this page.
In order to assign a
virtual network address
to the local network, check the
checkbox "Activate netmapping" and enter the address into the "Virtual net-
work address" field (e.g. 192.168.2.0). This virtual address is only visible from
the WAN side.
If, for example, the local address is 192.168.1.1/255.255.255.0, an entered
virtual address 192.168.2.1 will be changed to 192.168.2.0 and stored.
Save your settings by clicking "OK".
10.1.3
Enter Static Route
You can define static routes for forwarding data packets in the MLR 3G 2.0, which are
loaded during system start.
Configuration with the web interface
In order to enter a
static route
, change in the menu "Basic Settings" to the
page "Routing".
Enter
in the section "Add new route" the
Net address
, the
Netmask address
as
well as the
Gateway
into the respective fields.
In order to
delete an existing route
, check under "Existing routes" the check-
box of the route(s) to be deleted.
Save your settings by clicking "OK".
-
in the menus
"Dial-In" or "Dial-Out" on the respective page "Routing".
Neither a default gateway can be entered nor NAT can be enabled or dis
abled here. This is configured for the respective interface
35
