INSYS MLR 3G 2.0, Руководство пользователя

Страница: 29 / 114

MLR 3G 2.0 Commissioning

h
an antenna gain of more
2. of the network card,
3. twork
4. Connect the GSM antenna to the antenna connection of the MLR 3G 2.0.

e the IP address of the network
1. the MLR 3G 2.0 is con-


as IP address for the network
2. r the URL "http://192.168.1.1" into the

IP address is con-
figured in the MLR 3G 2.0. Press the reset key at the MLR 3G 2.0 three times

A dialogue will prompt you to enter a user name and password for authen-
3.
The regulation of the Federal Communications Commission (FCC) id valid
for the USA, according to which the antenna must be installed and oper-
ated in a distance of at least 20 cm to persons, not at the same place wit
other antennas or senders, and must not have
than 8.4 dBi (GSM 1900) or 2.9.dBi (GSM 850).
1. Locate the RJ-45 socket of the network card at the PC.
Make sure not to use the ISDN socket, but the socket
which you want to use to configure the MLR 3G 2.0.
Plug one end of the network cable into the RJ45 socket of the PC ne
card, and the other end into a network socket of the MLR 3G 2.0.
Configuring the MLR 3G 2.0

The MLR 3G 2.0 is connected to the PC.

The power supply of the MLR 3G 2.0 is present.
You have the required access rights to chang
card to which the MLR 3G 2.0 is connected.
Change the IP address of the network card to which
nected to an address, which starts with 192.168.1.
As an alternative, you may also configure your network card to "Automatic
address allocation". The integrated DHCP server of the MLR 3G 2.0 will then
allocate an address from the according address range to your network card.
Do not use the address 192.168.1.1. This is the factory default IP address of
the MLR 3G 2.0. For example, use 192.168.1.2
card in your PC.
Open an Internet browser and ente
address bar.

The browser loads the start page of the MLR 3G 2.0.
If you see the message in your browser window that the page with this ad-
dress cannot be found, follow the following steps: Check, whether your MLR
3G 2.0 is supplied with power. If yes, most probably a wrong
within two seconds and repeat this instruction from step 2.
tication.
Enter the user name "insys" and the password "mlr".
29