Inova TableBed, Инструкция по сборке, Страница: 44 / 55

Tech support is readily available if needed
Email: support@inovabed.com
Phone: 866.528.2804
A. The Footrest acts as an outrigger to stabilize
the entire TableBed and allow it to be
freestanding. After assembly and periodically
through the life of the unit, check to make
sure the (10) bolts holding the Footrest to the
Cabinet Front remain tight.
B. Periodically check to make sure the (8) bolts
holding it to the Table Leg remain tight.
C.
The (2) 3/8” bolts under the Footrest hold
the the spring mechanism anchor bracket in
place. This also holds the adjustment of the
the spring tension for the unit. Maintaining
the tightness of these bolts is crucial to the
safe use of the unit. Check them periodically
to make sure they are completely tightened.
D. Spring Balance of Bed: The position of the
two 3/8” bolts under the Footrest determine
how much spring tension is balancing the
weight of the bed as it is raised and lowered.
The ideal adjustment is to have as much
tension as possible, so the bed is easy to raise
and lower, but not so much that it “floats”
up after it is lowered. The adjustment MUST
only be made with the bed in the up position
(so there is no tension on the springs while
you are working). To increase the spring
tension, loosen the two 3/8” bolts under the
Footrest, slide them toward the Table Leg,
and retighten them. To decrease the tension,
loosen them, slide them away from the Table
Leg, and retighten them.
STEP 22:
Adjust the Spring Tension to the Lower Leg
A
Cabinet Front
Footrest
B
Footrest
Lower Leg
C
Hex Bolts
Lower Leg
Footrest
D
Footrest Hex Bolts
Lower Leg
Use this version of Step 22 if your TableBed has a Table Extension