Inoksan 7BG200, Инструкция по эксплуатации

Страница: 15 / 40

13
GB
WARNINGS
• The installation, the modification for another type
of gas and maintenance of the appliance must be
performed by qualified and authorised installers, in
compliance with current safety regulations.
• Disrespect of the instruction given by producer with
the appliance (Use, maintenance, gas connectin,
technical data table and data plate) may compromise
the appliance safety and will result in immediate
loss of the warranty. The manufacturer declines all
responsibility for injury or damage to persons or
things, due to disrespect of the instructions.
• Gas connection of the appliance must be according
to the instructions given on the “T1” table.
• The instructions contained in this manual give
important regarding security for installing and
maintaining the appliance. The manufacturer
recommends that this manual be carefully stored
in the work zone where it can be consulted by
technicians and workers.
INSTALLATION
Positioning
• Only install the appliance in well-ventilated
premises.
• Bain-maries are “A” type appliances. For this
reason, premises must be ventilated as stipulated by
current technical regulations.
• Position the appliance at least 10 cm from the walls
of adjacent units. This distance may be less if the
adjacent walls of units are insulated or heat resistant.
• This appliance is not designed for built-in
installation.
Installation (Fig.-1)
• Carefully remove the protective film from the
external panels to avoid leaving any trace of glue.
Use a suitable diluent to remove any glue residue.
• If you will use the appliance with cupboard, use
reference pins to put the appliance on cupboard and
set the balance of unit with foot(4 pcs.) on flat floor.
• If you will use the appliance on support leg system,
use reference pins to put the appliance on leg
system.
• If you will use the appliance on working table, use
plastic foot at the bottom of appliance and drill a
hole for discharge of bain marie.
• In the case of cantilever installations, refer to the
corresponding instructions.
Connection of adjacent appliances (Fig.-2)
• Position the appliances next to each other and level
to the same height.
• Connect the appliances using the fixing holes drilled
in the sides of the work top.
Gas connection
• Before installing the appliance, contact the local Gas
Supply Authority to cheek the compatibility of the
gas supply.
• Gas inlet can be made from under or behind
the appliance.
• A rapid-action gas shut-off valve must be fitted
upstream of the appliance in an easily accessible
position.
• Make sure the appliance corresponds with the gas
supply to which it is connected. If it does not,
convert as instructed in the section “Conversion to
different type of gas”.
• Once the appliance has been installed, cheek for gas
leaks at the connection points.
• All pieces needed for montage will be supplied by
INSTALLATION INSTRUCTIONS