Inoksan 7BG200, Инструкция по эксплуатации

Страница: 17 / 40

15
with minimum resolution of 0.2 mbar.
• Detach the control panel from the appliance, remove
the screw “B” from pressure point and connect the
pressure gauge pipe.
• Ignite the burners and measure the inlet pressure.
• The pressure reading must correspond with the
ratings shown in table “T3”. If not, switch off the
appliance and contact your local Gas Supply
Authority immediately.
• Disconnect the manometer pipe and retighten the
screw “B” in pressure point.
TROUBLESHOOTING GUIDE
The pilot burner does not ignite or ignites with dif-
ficulty
• Insufficient gas pressure.
• The gas line or injector is clogged.
• The gas cock is faulty.
• The piezoelectric ignition is faulty.
The pilot burner goes out during use
• The thermocouple is faulty, insufficiently heated or
incorrectly connected to the valve.
• The gas cock is faulty.
The main burner does not ignite or ignites with
difficulty
• Insufficient gas pressure.
• The injector is clogged.
• The gas cock is faulty.
REPLACEMENT OF SPARE PARTS
• Always cheek for gas leaks after carrying out
maintenance work or repairs on the appliance.
Main burner, Pilot burner, Thermocouple and Pilot
burner ignition electrode
• Remove the control panel from the appliance and
replace the component.
Gas cock and Piezoelectric ignition
• Remove the control panel from the appliance and
replace the component.
INSTRUCTIONS FOR USE AND
MAINTENANCE
WARNINGS
• Beware of the appliance’s hot surfaces! This
appliance is intended for professional use and
must only be used by trained staff. This appliance
is exclusively designed to cook food. Any other use
shall be deemed improper.
• IMPORTANT : Do not ignite the burners when
the tank is empty.
• If the appliance breaks down, close the gas shut-off
valve upstream of the appliance.
• Only contact the technical service centre authorised
by the manufacturer and only use original spare
parts.
• Before using the appliance for the first time,
thoroughly clean all the food contact surfaces.
• For the cleaning, fill the tank up to the upper table
with water and detergent. Boil the water for a few
minutes, clean it and in the end rinse with clean
water.
• The thermocouple stops the gas circuit in cases of
overheating of the water, so it provides the operation
security.
USE
Operation
• The control knob is marked as follows:
● Off
P Pilot ignition
1 Minumum water temperature
2..7 Medium water temperatures
8 Maximum water temperature
GB