Innovatech TERMINATOR-2000e, Руководство по эксплуатации и обслуживанию

Страница: 14 / 58

INNOVATECH PRODUCTS AND EQUIPMENT CO., INC. 14
Left Handle:
Push lever down to turn
the machine to the right.
Right Handle:
Push lever down to turn
the machine to the left.
Figure 2 - Operator Controls
Operator Controls
The operator controls consist of the drive and blade height levers, a key switch and a foot pedal.
The DRIVE AND BLADE CONTROLS (three levers) are located directly in front of the operator
seat. The drive levers (left and right) control the motion of the rear wheels. The blade height lever
(center) controls the vertical position of the blade. Use these controls as follows with foot pedal
pressed down.
From the view of the seated operator:
Push the left and right levers down
together and hold them in position then slowly depress the foot
pedal to move the machine forward.
Pull the left and right levers up together and hold them in position then slowly depress the foot pedal
to move the machine in reverse. (The alarm sounds.)
Push only the left lever down to turn the machine to the right. Push only the right lever down to turn
the machine to the left.
To adjust the blade down, push and hold the center lever down and press the foot pedal to move the
blade down. To adjust the blade up, pull and hold the center lever up and press the foot pedal to
move the blade up.
AUTO STOP: When you release the drive or blade lever, the motor continues to run (with foot control
depressed) but the drive or blade motion automatically stops and will not start again until you push or
pull the levers again.