Innovatech TERMINATOR-2000e, Руководство по эксплуатации и обслуживанию

Страница: 11 / 58

INNOVATECH PRODUCTS AND EQUIPMENT CO., INC.
11
UNCRATING THE TERMINATOR ® AND PREPARING IT FOR OPERATION
When you receive the Terminator®, inspect the outside of the crate completely, to detect damage to the
crate itself. If it is damaged, notify the carrier immediately and follow his/her instructions to file a claim.
Carefully uncrate the machine and inspect it for damage that may have occurred during shipping. If the
shipment is damaged, notify the carrier immediately and file a claim in the normal manner.
Check packing slip for complete shipment. If shipment is incomplete, notify our Customer Service
Department within 24 hours.
Remove the crate debris, set aside the blades and other packages, and prepare the Terminator® for
operation:
Raise the hood and prop it open with the hood brace. Be sure the tip of the brace is firmly secure under
the latch.
DO NOT MOVE THE TERMINATOR MACHINE WITH THE LID OPEN!
Inspect batteries for spillage during shipment. Check battery water levels before starting the
Terminator

.
CAUTION! Wear acid-resistant gloves and safety glasses use extreme care when checking
battery water levels.
DO NOT WORK NEAR A FLAME OR SPARKS.
To remove the TERMINATOR® from crate with a forklift:
1) Remove footrest by pulling the clevis pins out, which are located on the right and left hand sides,
then disconnect the throttle cable. Pull out footrest; this will then expose the forklift slots.
To remove the TERMINATOR® from crate without a forklift:
1) Plug the battery connecters together.
2) Take 2 x 4’s off the edge of the crate and between the wheels.
3) Place 2 x 4’s behind the crate of the rear of the machine.
4) Make a ramp with the 2 x 4’s and the crate material.
5) To enable power to the TERMINATOR®, turn the key, pull up on red knob.
6) Lift front wheel off of the crate 5 inches by pushing down on middle valve. (Jaw will be on crate).
Remove feet from area.
7) Lift up on the left and right handles and depress the foot pedal slowly. The machine will start
moving slowly backwards.
8) Ensure that both rear wheels come off the crate evenly. Failure to back off evenly could result in
the machine tipping over and harm to the operator.
9) As machine rolls back, make sure center wheel clears the crate. If center wheel does not clear
the crate, depress the center handle while pressing the foot pedal until the wheel clears the
crate.
10) Once machine is on the ramp, slide all the way to the bottom, then lift jaw up and set center
wheel down to the ground.
11) Whenever mounting or dismounting the TERMINATOR®, ALWAYS disable the power by
pressing down on the red power knob.