Innovatech TERMINATOR-2000e, Руководство по эксплуатации и обслуживанию

Страница: 27 / 58

INNOVATECH PRODUCTS AND EQUIPMENT CO., INC.
27
Carbon Dioxide is a non-toxic gas normally present in the air, which can reduce the oxygen content of the
air from the normal 21% by dilution or displacement. Air containing 16% or less oxygen may cause injury
or even death to a person breathing in such an environment. While good ventilation will control the carbon
dioxide hazard in open spaces, extra special care must be taken when neutralizing significant quantities
of sulfuric acid in closed areas with the above type of chemical.
Lime, caustic soda and ammonia or ammonium hydroxide do not release carbon dioxide when
neutralizing sulfuric acid but are very strong chemicals themselves and should ONLY be used by
qualified, chemically trained individuals.
Connecting/Disconnecting Charger
Always turn the charger off at the charging unit before connecting or disconnecting the battery charger
leads. The Battery Connector below the seat is shipped in a disconnected state, this connector will have
to be plugged in order to operate the Terminator 2000e.
It is also good practice to leave this main power connector unplugged during storage.
Live leads can cause arcing and sparks which could cause an explosion if battery gases are present,
please check that the main contactor/disconnector is not in the on condition when you connect or
disconnect the battery terminal plug. In addition, the battery connector terminals will became pitted over
time resulting in poor connections and increased heat generation in the battery leads and connectors.
Basic Charging Facts
•
Proper charging is essential for maximum battery life.
•
In general, the proper charging rate is any rate that does not produce a battery temperature
higher than 115F or 46C, and or does not produce excessive gassing.
* The Terminator 2000e is supplied with a CEN 48V 50 Amp charging unit, which has been sized to give
optimum charging time without causing excessive heating or off gassing.
*
Do not use a 12v battery charger on the Terminator 2000e battery pack this will cause damage to the
charger as well as the battery pack.
* When a discharged battery is initially placed on charge, it will draw a current equal to or close to the
chargers maximum output. As the battery voltage rises back to its rated voltage the chargers output will
adjust down automatically to assure a safe, efficient charging rate during all stages of the charge
* The CEN Charger is designed to start and stop so as not to under or over charge the battery pack. The
“smart” charger has a computerized control unit, which can determine when the battery is fully charged
and then automatically end the charge cycle.
•
There are two important types of charge that are used for lead-acid deep-cycle batteries.
•
Standard Re-charge and an Equalizing Charge.
Standard Re-charge:
After a battery has undergone a normal full shift and has been fully or partially
discharged , it must undergo a standard charge. Normally a standard recharge is based on an 8-hour
charging cycle.