Inmarsat EXPLORER 527, Руководство пользователя

Страница: 65 / 152

Chapter 4: Using the interfaces
TT 98-123789-D Using a computer 57
Using the USB service interface
Before connecting to the USB service interface
The USB (Universal Serial Bus) service interface of the EXPLORER 527 is intended for accessing the
settings of the transceiver in a service situation, using AT commands.
To connect to the USB service interface, use a USB cable mounted with a type B connector. For
specifications, refer to USB service interface on page 127.
First time setup of USB
If it is the first time you connect your computer to the EXPLORER 527 using the USB service
interface, or you have exchanged the EXPLORER 527 with another EXPLORER 527, you must install
a driver as follows:
1. Power on your computer.
2. Connect the USB cable to the USB port of your computer.
3. Connect the other end of the cable to the USB
connector, marked
USB , on the rear connector
panel of the EXPLORER 527.
4. Power on the EXPLORER 527 as described in
Getting started on page 11.
5. Your computer should now automatically discover that new hardware is connected.
6. On Windows XP , the New Hardware Wizard starts automatically. Go through the wizard as
follows:
7. In the New Hardware Wizard, select No, not this time when you are asked if Windows can
search for software.
8. Click Next .
9. Insert the Thrane & Thrane CD-ROM provided with your EXPLORER 527 into the CD-ROM drive
of your computer.
10. Select Install the software automatically and click Next .
11. If you get a warning that the software has not passed Windows logo testing, you can safely
click Continue Anyway .
12. Click Finish when the installation is complete.
When you finish the wizard, the Thrane & Thrane EXPLORER USB driver is installed.
Note
The following description is for Windows XP . If you are using a different operating
system, the procedure may be different.