Inmarsat EXPLORER 527, Руководство пользователя

Страница: 37 / 152

Chapter 3: Using the display and keypad
TT 98-123789-D 29
Display during start-up
Start-up sequence
After power on you are asked for a PIN.
When you have entered the correct PIN, the display shows the Main screen.
While the antenna is attempting to connect to the BGAN network, the Main screen shows the
progress as follows:
•
SEARCHING:
The EXPLORER 527 is searching for the network operator.
•
REGISTERING:
The EXPLORER 527 is registering itself on the BGAN network.
If the GPS position has not yet been acquired at this point, the display will show
NO GPS
. For further information, see the Troubleshooting Guide on page 111.
•
READY:
The EXPLORER 527 is registered on the network and is ready to go online.
If a computer is already connected, the display will show
DATA
instead of
READY
.
Main screen
The Main screen is shown after passing the
PIN screen, and anytime you leave the menu
system.
The Main screen shows the most important
status of the EXPLORER 527 such as signal
strength and general status.
The Main screen also shows icons for any
interfaces that are turned on.
In this case, the Phone/Fax interface, the USB
service interface and the LAN interface are all on.