Installation and programming manual
Settings
27
Note:
Voice -message playback over-the-phone starts either after
detection of a voice answer from the call recipient or, if the
No voice check
option is enabled, immediately after the
number has been dialed.
Recording voice messages
You can record the voice messages by connecting an ordinary touch-tone
phone to connector J6 on SmartLogos60 board. See also paragraph
7.2.6
Connecting the SmartLogos60 board
”.
The recording procedure is as follows:
1.
Lift the receiver.
2.
Press “1” and wait for 1 beep.
3.
Press the number of the message (1 to 8) which you wish to record and
wait for the confirmation beep.
4.
Wait for a second beep (which signals the start of the recording) and
record the message (maximum 10 seconds). You can stop recording at
any point by pressing “0”. The end of the recording will be signaled by
two beeps.
5.
To record another message press “1”, to listen to the recorded-message
press “2”, or hang up.
The playback procedure is as follows:
1.
Lift the receiver.
2.
Press “2” and wait for 2 beeps.
3.
Press the number of the message (1 to 8) which you wish to listen to and
wait for the confirmation beep.
4.
The message playback will start. You can stop playback at any point by
pressing “0”.
5.
To listen to another message press “2”, to start the message-recording
phase press “1”, or hang up.