Installation and programming manual
Installation
19
7.2
Connections
7.2.1
Connecting the land line (PSTN)
Connect the land line (PSTN) to terminals 15 and 16.
7.2.2
Connecting telephone devices
Connect any line-sharing devices (phone, fax, control panel, etc.) to terminals 13
and 14 and connect the land line (PSTN) to terminals 15 and 16.
During normal operating conditions, terminals 13 and 14 are connected
internally to the land line terminals (15 and 16). When the SmartLink-P is
about to make a call, it disconnects the devices connected to terminals 13
and 14 and dials the number on the land line (PSTN). Therefore, for security
reasons, it is advisable to connect the telephone line to terminals 15 and 16
and all other telephone devices to terminal 13 and 14.
7.2.3
Earthing
Terminal 12 must be earthed.
Danger:
This operation is telecommunications network safety
regulations compliant and protects the device against
overload and/or electrical discharge from the external
telephone line.
7.2.4
Connecting the tamper microswitch
Connect terminals 10 and 11 to the external tamper line.
7.2.5
Connecting the IN&OUT terminals
Connect the terminals to the command device/devices to be commanded, as
described in paragraph
8.7 Programming the Inputs and Outputs — IN&OUT
.
7.2.6
Connecting the SmartLogos60 board
Figure 6 - SmartLogos60 table
Insert connector [B] of the voice board into the connector on the SmartLink-
P board (table on page 12, ‘[H]’). Ensure that connector [A] is positioned to
your right.
A
B