InfoPrint 5504-R40, Руководство пользователя

Страница: 142 / 402

142
Chapter 3
PRINTER CONTROL
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode.
Pressing any key removes the power saver message from the control panel.
Sending a print job to the printer also turns off power saver mode.
The options are 1, 5, 10, 15, 30, 45, 60, and 240 minutes.
The factory default is 5 minutes.
Pwr Save Control
Pwr Save Control allows you to enable and disable Power Saver mode. If
enabled, the menu for Power Saver Time is in effect.
The options are Enable (the factory default) and Disable.
Display Language
This parameter chooses the language that will appear on the LCD: English,
German, French, Italian, Spanish, or Portuguese.
The factory default is English.
Alarm
•
On . An audible alarm sounds (3 beeps) when a fault occurs, such as a
paper jam.
•
Cont. Beep . A continuous audible alarm sounds when a fault occurs,
which can be stopped by pressing CLEAR.
•
Off . No audible alarm sounds.
The factory default is On.
Power-up State
•
Online . The printer powers up in the online state.
•
Offline . The printer powers up in the offline state. This selection must be
saved as a power-up configuration to be used.
The factory default is Online.
Ptx Setup SFCC
Allows you to choose the hex value of the ASCII character you wish to use as
the SFCC for the PTX SETUP command. Valid hex values are 01-FF.
The factory default value is hex 21, which corresponds to the “!” character.