Copyright ©2018, Infoblox, Inc.All right reserved.
1.
2.
3.
4.
1.
2.
3.
4.
5.
Two-Post Rack Mounting
Infoblox provides a pair of rack mounting ears as part of the Accessory Kit for your appliance. For optimal physical stability of the appliance in a
two-post installation, you use the provided ears to mount the appliance from its rear to the posts of the rack.
To mount the appliance to an equipment rack and secure it at the rear rack posts:
Align the mounting holes on the rack ears with the lower front mounting holes on each side of the chassis.
Attach a rack ear on each side of the chassis with two (2) 8-32 screws, as shown in the figure below. Only one location on each side will
perfectly match the screw holes on each rack ear:
Rack Ears for Two-Post Rack Mount
With one person on each side, lift the appliance and position it in the equipment rack.
Attach each rack ear to the equipment rack with two (2) 10-32 screws on each side.
Four-Post 600mm Rack Mounting
Caution
: The Four-Post 600mm chassis rack rails kit provided with the Infoblox 4005 Series appliance provides only a limited range of travel. It
does not extend through the entire depth of the equipment rack. Exercise caution when withdrawing the appliance from its position in the
equipment rack.
For a four-post rack mount, you combine the bundled pair of rack ears with a pair of chassis rack rails providing up to 600mm depth in a four-post
rack. The chassis rack rail assembly is bundled with the appliance at time of purchase. This kit also is provided as a field-replaceable unit. For
information, see
.
International AC Power Cords
Align the mounting holes on the rack ears with the front-most mounting holes on each side of the chassis.
Attach the rack ears (provided as part of the Accessory Kit) to the front end of each side of the chassis with two (2) 8-32 screws, as
shown in
.
Rack Ears for Two-Post Rack Mount
Slide the inner chassis slide rails out of the rack slide brackets, as shown in the figure below.
Chassis Slide Rail and Rack Slide Bracket
Align the mounting holes on the chassis slide rails with the rear-most mounting holes on each side of the chassis. Ensure that you place
the chassis slide rails in the correct orientation. Otherwise, the mounting holes do not align properly.
Attach the chassis slide rails to each side of the chassis with two (2) 8-32 screws, as shown in the figure below.
Chassis Slide Rail alignment with chassis (Four-Post mount)
