18
19
STANDBY MODE
Standby mode may be activated either manually or automatically to
conserve the battery life of the rifle scope.
Automatically Enter Standby Mode
In the main menu, the BOLT TD50L may be set to automatically enter
standby mode after a specified time with no operation (10, 20, or
instructions.
1. In the main menu, select the desired standby time, 10, 20,
Standby
instructions.
2. The standby icon and status (10min, 20min, 30min, or off)
appear in the status bar.
3. Once set, the BOLT TD50L will automatically enter standby
mode, after the set number of minutes of inactivity, to conserve
battery life.
4. Short press the
Power
Button
to exit standby and return to
the home screen.
NOTES:
• When
10min
,
20min
, or
30min
is selected:
• The BOLT TD50L will enter standby mode automatically
when the BOLT TD50L is tilted up or down at an angle of
more than 70° or left or right at an angle of more than 30°.
• The BOLT TD50L will not enter standby mode while it is in a
level firing position.
• When
off
is selected, standby mode is turned off and the rifle
scope will operate until the batteries run out.
Manually Enter Standby Mode
Standby mode may be activated manually from the home screen at
any time.
1. Short press the
Power
Button
to enter / exit standby mode.
Adjusting the Focus
ADJUSTING THE DIOPTER/EYEPIECE
1. Rotate the eyepiece diopter adjustment ring
(2)
at the rear of the
rifle scope right or left until the user interface is clear.
2. Look closely to ensure all icons in the status bar, and the reticle
appear sharp and in focus. No additional diopter adjustments are
required unless the user wishes to make changes.
NOTES:
• After this initial adjustment, there is no need to rotate the
eyepiece adjustment ring
(2)
for long distances or any other
conditions.
• If necessary during standard use, you may rotate the objective
lens focus ring
(14)
to adjust fine focus on the target object being
observed. See
FOCUSING THE OBJECTIVE LENS
To adjust the focus on the target object:
1. Open the objective lens cap
(15)
.
2. If the sunlight is too bright, you may leave the lens cap closed to
prevent the image from being overexposed.
3. Rotate the objective lens focus ring
(14)
left or right to focus on
the target object being observed.
NOTE: Re-adjusting the focus will be needed if the distance to
your target changes.
Activating / Deactivating the Reticle
The reticle is inactive when the BOLT TD50L is powered on for the
first time. To activate the reticle, or to deactivate it at a later time:
1. From the home screen, press and hold the
Brightness
and
Palette Buttons
at the same time for more than 15 seconds.
Adjusting the Rifle Scope Image Settings
If you did not complete Step 4 Adjust the Image Settings in the Quick
Start Guide to adjust the image settings, go ahead and follow the
steps below.
From the home screen:
1. Short press the
Palette Button
to set the imaging mode, day,
moon, and star. Day is the default.
2. Short press the
Brightness
Button
to adjust the screen
brightness, from level 1–5. The default is 3. The selected
brightness level appears in the status bar.
3. Rotate the
Control Turret
to zoom in and out on the observed
object. See
4. Long press the
Palette Button
to turn on the PIP window, if
