16
17
16. MOUNTING THE INFRARED
ILLUMINATOR
The TD50L includes an optional Infrared Illuminator that can be used
to supplement available light when conditions require. To use the
Illuminator, you must first install it onto the included QD mount:
1. Install the body of the Illuminator into the smaller-diameter end
of the mount and use the included Allen wrench to tighten the
two screws until snug.
2. Open the larger-diameter end of the Illuminator mount by
loosening the tension arm on the top of the mount.
3. Place the open end of the mount around the body of the TD50L,
ensuring that the placement will not impair the operation of the
scope or weapon, and tighten the tension arm to secure it.
4. Twist the tension arm to adjust tension, as needed.
To turn the Illuminator on and adjust the beam angle:
1. Turn the tail switch to cycle between the three available power
levels (low, medium, and high output).
2. Once a suitable power lever is selected, adjust the beam path by
turning the bezel of the Illuminator (flood to beam).
3. Using the included Allen wrench, slightly loosen the two screws
on the small side of the mount holding the Illuminator in place.
4. Adjust the Illuminator by pointing it so that the beam lands in
the desired position in your sight picture, and retighten the two
screws.
CAUTION:
Never look directly into the beam of the Illuminator to
check operation. The Illuminator uses concentrated infrared light,
which while not visible to the human eye, can cause permanent
physical damage.
17. OPERATING INSTRUCTIONS
Control Features
The BOLT TD50L is operated via four control buttons and a large
metal tactile control turret. The large, easy-find control turret provides
audible and tactile feedback when twisted and when pressed.
The control buttons can be used to perform shortcut operations from
the home screen, as well as in the menu and full-screen interfaces.
See
Description of Control Buttons and Shortcuts
shortcut button details.
Powering On / Starting
1. Open the objective lens cap
(15)
.
2. Long press the
Power
Button
for 2 seconds to power on the
BOLT TD50L. The home screen appears after 3 seconds.
To determine the current charge of the built-in battery pack, check
the battery icon on the right side of the status bar at the top of the
viewscreen. See
WARNING:
Don’t point the objective lens towards any intense
energy sources, such as laser radiation or the sun. This may render
the electronic components inoperative. The warranty does not
cover damage caused by improper operation.
Powering Off / Stopping
To power off the BOLT
TD50L:
1. Press and hold the
Power
Button
.
The standby screen
will open, showing a
3-second countdown.
2. Continue holding
the
Power
Button
until the
3-second countdown
completes.
NOTE: Releasing the
Power
Button
at any time before the
countdown reaches zero will stop the shutdown process.
WARNING:
Do not remove the power supply when saving data,
otherwise the data may not be saved.
00:03
