Infinity Solutions 7K Plus, Руководство по обслуживанию

Страница: 18 / 52

18
8. Rolls
Note: If roll configuration is different than shown, see addendum
Figure 18: Rolls
a) Removal
•
Disconnect the power cord from the machine.
1. Remove the all drive train components. (See Section: 2)
2. Remove the fold trays , simply lift up trays and slide out of chassis.
3. Remove the feed gauge x-tie mounting screws from the drive train side of the chassis. (See Figure 19)
4. Remove the feed table mounting screws from the drive train side of the chassis. (See Figure 19)
5. Remove the feed roller mounting screws from the drive train side of the chassis. (See Figure 19)
6. Remove the conveyor table mounting
screws from the drive train side of the
chassis. (See Figure 19)
7. Remove the nip wheel x-tie mounting
screw from the drive train side of the chassis.
(See Figure 19)
8. Remove the drive motor guards and the
drive motor mounting screws. The drive
motor can be left in the machine.
9. Ensure the electrical side cover is in place
and on a sturdy surface tip the machine so
that the electrical side is face down. Ensure
the drive motor is securely resting and no
wires are being pinched or stretched.
10. Remove the base plate mounting screws
and rear leg from the drive train side frame.
11. Slide the drive train side frame off of the
rolls and remove.
SERVICING THE ROLLS