Infinity Solutions 7K Plus, Руководство по обслуживанию

Страница: 13 / 52

13
b) Installation
1. Installation is the reverse of removal.
3.2. Feed Drive Belts
a) Removal
•
Disconnect the power cord from the machine
1. Remove the E-clips from the drive shaft (4x).
2. Remove shaft support screws from the side frames . (See Figure 19)
3. Slide the drive shaft through the drive train side frame .
4. Pull the idler shafts out the back side of the chassis.
5. Remove the belts .
a) Inspect the belts for any wear or damage. If any is found replace the belts.
b) Installation
1. Place the idler rollers onto the idler shafts and place the belt around the rollers .
a) Insert the drive roller inside the belts . (Note: ensure that
the 1-way bearing is positioned on the side closest to the
electrical side frame)
b) Insert the idler shafts, rollers and belts into the chassis and
insert shaft screws into the side frame.
Note : The crowned roller goes to the back of the machine. (See
Figure 10)
2. Insert the drive shaft through drive train side frame , insert the
shaft into the drive roller as the shaft is being inserted into the
side frame.
3. Replace the E-clips (4x).
4. Ensure belts are aligned and are oriented with the blue side
visible.
5. Reinstall feed pulleys and belt.
c) Adjustment
Paper Feed Tray Width Adjustment
Place a squared up stack of the paper to be used into the tray and align the paper to the fixed side of the tray.
Adjust the sliding side so that there is approximately 1/8 inch between the stack of paper and the guide. If there is
no gap the paper may bind and not feed; if too loose paper may feed crooked.
Figure 12: Feed Rollers and Belts