Infinity Solutions 7K Plus, Руководство по обслуживанию

Страница: 14 / 52

14
4. Feed Gauge
Figure 11: Feed Gauge Assembly
a) Removal
•
Disconnect the power cord from the machine.
1. Remove the feed gauge cover .
2. Remove both side covers .
3. Remove the x-tie screws from both side frames.
(See Figure 19)
4. Pull the feed gauge assembly up and out of the
machine.
Note: If the x-Tie is too tight in the chassis to remove it
maybe necessary to loosen the feed table , feed idler
shafts , conveyor , sensor x-tie , and front & rear
motor guard screws on the motor side frame . (See
Figure 19)
b) Installation
1. Assembly is the reverse of the removal.
2. Adjust the feed gauge .
c) Adjustment
•
Disconnect the power cord from the machine.
1. Remove feed gauge cover
2. Place 1 form on the feed table and hand feed the form into the machine by moving the feed belt with your
hand.
3. Pull the paper out of the machine. You should feel resistance, but not too much. Turn the adjustment screw
clockwise for less resistance and counter-clockwise for more resistance.
Figure 12: Cross-section of Feed Gauge
Adjustment Screw