Infinity Solutions 7K Plus, Руководство по обслуживанию

Страница: 23 / 52

23
Note : The Feed Gauge Cover is
only removed for the purpose of
illustration of the doubles sensor
9.6.3 Sensor Alignment
1. Visually align the support brackets so that the cables are pointing at one another.
2. Fine tune the alignment by slightly rotating the bracket until the highest reading is displayed on the optic
amplifier. This number should be approximately between 2000 and 3000.
9.6.4 “Teaching” the Optic Amplifier
1. Press on the touch screen.
2. Deactivate the doubles detection.
a) Turn off the doubles detection, press and the status will be changed to .
3. Manually feed your selected form into the machine.
4. Place the form on the feed table and from under the feed
table rotate the feed belts to feed the form into the
machine until it has passed between the doubles sensor.
5. If your form has a window ensure that it is not oriented
such that it is between the sensors. In the below image the
location of the doubles sensor can be seen.
6. Touch the button once.
7. Manually feed a second form under the first sheet.
8. Touch the button again to finish.
9. Turn the doubles detection .
10. Touch button and exit the setup menu.
11. Test that “Teaching” the machine was successful
a) Feed a single piece of paper into the machine, no messages should be displayed. If a “Doubles Detected”
message is displayed repeat the “Teaching” process.
b) Feed two pieces of paper into the machine so that they cross under the sensor. An error message will be
displayed, if the message is not displayed repeat the “Teaching” process.
c) The results can also be tested by observing the two indicator lights on the far right of the optic amplifier.
(a) The top light indicates no sheets or one
sheets.
(b) The bottom light indicates that two sheets
are detected.
d) If the above is not the case repeat the
“Teaching” steps.
9.7. Feed Counter
a) Removal
•
Disconnect the power cord from the machine.
1. Remove the upper fold plate , simply lift the plate
up and slide it out of the machine.
2. Remove the felt holder, remove the thumb
screws and slide out of the machine.
3. Disconnect the cable from the reflective sensor .
4. Remove the sensor bracket from the x-tie .
On
Done
Teach
Teach
Off
Setup
Sensor
ON
Doubles Sensor
Feed Belts
Feed Table
Figure 23: Feed Table