Infinity Solutions 7K Plus, Руководство по обслуживанию

Страница: 17 / 52

17
that the belts for the extended conveyor are on the pulleys .
3. Reattach extended conveyor arm .
4. Orient the shaft such that the bore for the spring is aligned with the notch for the spring, insert springs .
5. Insert E-Clips onto the intermediate idler shaft (4x).
6. Place and hold the final idler rollers inside the extended conveyor belt .
7. Slide the final idler shaft in place.
8. Insert E-Clips (4x).
9. Orient the shaft such that the bore for the spring is aligned with the notch for the spring , insert springs .
10. Reattach the feet so that the conveyor table sits evenly.
7. Wiper
3
2
1
Bri-Lin Corporation
16 Amarosa Drive
Rochester, NH 03868
B
L
DRAWING TITLE
WIPER ASSEMBLY
PART # REVISION DRAWN BY
DRAWING # SCALE DRAWING DATE
18-0219-00
MD-0219-00 A
1/11/2005
AAS
MATERIAL
FINISH
UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS ARE IN INCHES
TOLERANCES:
ANGLES 1
1 PLACE DECIMALS .05
2 PLACE DECIMALS .010
3 PLACE DECIMALS .005
4 PLACE DECIMALS .0005
1:1.5
THIS DOCUMENT AND THE DATA DISCLOSED HERIN OR
HEREWITH IS NOT TO BE REPRODUCED, USED OR DISC-
LOSED IN WHOLE OR IN PART TO ANYONE WITHOUT THE
PERMISSION OF BRI-LIN CORPORATION
ITEM PartNo DESCRIPTION QTY.
1 70-0220-00 Felt Holder 1
2 70-0221-00 Wiper Felt Strip 1
3 84-0164-00 Black #10-32 Thumb Screw 3
Figure 17: Wiper Assembly
a) Removal
1. Remove all three thumb screws .
2. Slide the wiper assembly off the x-tie and remove from the machine.
3. Inspect the felt wiper , if it is dirty flip over or replace.
b) Installation
1. Slide the wiper assembly in place.
2. Insert the two thumb screws facing out the front of the machine.
3. Adjust the pressure on the roll so the felt is slightly touching. Check that the holder is parallel with the roll .
Note: If the felt is pressing too hard on the roll it can increase the load on the motor and reduce the performance
of the machine. If the felt is not contacting the roll it will not properly clean and can mark up the forms with ink.
4. Insert the last thumb screw into the top of the felt holder .