Firmware User Manual (AE-step)
62
Revision 1.02
2019-04-24
TLE984x Firmware User Manual
EOT Block
Returned error codes
The message can return the following error codes:
- ERR_LOG_CODE_NVM_IS_READ_PROTECTED
- ERR_LOG_CODE_100TP_READ_ADDRESS_INVALID
- ERR_LOG_CODE_NVM_SEMAPHORE_RESERVED
- ERR_LOG_CODE_CS_PAGE_CHECKSUM
- ERR_LOG_CODE_CS_PAGE_ECC2READ
Table 4-29 “Command 8E
H
– NVM: 100TP Read” Data Block Field Description
Field
Description
Length
Number of following bytes in the data block. Always set to 06
H
Message Type
Data block. Always set to 00
H
Data
It contains the read data.
Table 4-30 “Command 8E
H
– NVM: 100TP Read” EOT Block Field Description
Field
Description
Length
Number of following bytes in the EOT block. The value depends on the size of the Data
field:
• LIN – always 2 to 6 bytes
• FastLIN – 2 ... 128 bytes
Message Type
EOT block. Always set to 80
H
Data
The maximum size of the field depends on the used BSL interface:
• LIN – 5 bytes
• FastLIN – 128 bytes.
Contains the read data.
The EOT block message is the last message for read bytes. The data read process does
not use Data Block messages if the overall data size is equal to or smaller than the "Data"
field.
BSL20_MODE_EOT
.
0
Length
1
2...129
Data
Message
Type
