Firmware User Manual (AE-step)
52
Revision 1.02
2019-04-24
TLE984x Firmware User Manual
Data Block
This block is only used for LIN communication, because the LIN frame length is too short to place the
maximum supported data length into the EOT block.
EOT block
Table 4-20 “Command 87
H
– NVM: Read Data” Data Block Field Description
Field
Description
Length
Number of following bytes in the data block. Always set to 06
H
Message Type
Data block. Always set to 00
H
Data
It contains the read data.
Table 4-21 “Command 87
H
– NVM: Read Data” EOT Block Field Description
Field
Description
Length
Number of following bytes in the EOT block. The value depends on the size of the Data
field:
• LIN – always 2 to 6 bytes
• FastLIN – 2 ... 128 bytes
Message Type
EOT block. Always set to 80
H
Data
The maximum size of the field depends on the used BSL interface:
• LIN – 5 bytes
• FastLIN – 128 bytes
Contains the read data.
The EOT block message is the last message for read bytes. The data read process does
not use Data Block messages if the overall data size is equal to or smaller than the “Data”
field.
BSL20_MODE_DATA
.
Data
0
2 – 6
Length
1
Message
Type
BSL20_MODE_EOT
.
0
Length
1
2...129
Data
Message
Type
