Inficon HAPSITE Smart, Руководство по эксплуатации

Страница: 67 / 554

2 - 29
IP
N 07
4-
39
7-
P1
G
HAPSITE Smart Operating Manual
8
Snap on the black cover labeled Sample Loop. See Figure 2-41 .
Figure 2-41 Sample Loop Cover Installed
2.9.2 Removing the Sample Loop
1
Open the front panel of the HAPSITE and remove the black cover labeled
Sample Loop .
WARNING
The elbow fittings and nuts may be hot. If necessary, let
the elbow fittings and nuts cool down before continuing.
2
Using the 7/16" open end wrench suppled by INFICON, loosen the nuts on the
top and bottom of the sample loop until it becomes free.
3
Remove the Sample Loop, being careful not to lose the ferrules on the top and
bottom. Store the Sample Loop in a safe place for future use.
2.9.3 Installing the Tri-Bed Concentrator
1
Refer to section 2.9.2, Removing the Sample Loop, on page 2-29 to remove
the sample loop or to section 2.9.5, Removing the Concentrator Tube, on page
2-36 to remove the currently installed concentrator tube.
2
Remove the Tri-Bed Concentrator tube from the storage vial. Orient the plastic
nuts and Teflon ferrules onto the glass concentrator tube by placing a nut on
each end of the tube with the threaded end facing away from the center of the
tube.
3
Place the wide end to the ferrule into the threaded end of each nut.