Index Braille
Manual Index Everest
Page 10
January 2000
Verson 8.20/9.20
4.3
Loading the sheet feeder
a) Set the right margin guide to the correct position. To the right, if the margin is set by the
position of the paper, and to the left, if the margin is defined from the setup.
b) Open the sheet feeder with the button on the side of the sheet feeder.
Load the paper and move the left paper guide until is slightly touch the paper and lock both paper
guides properly.
Note that Everest prints the page up-side-down so that the right paper margin guide is against the
left side of the printed paper. (See picture below)
c) When loading the sheet feeder with paper, make sure it is not overfilled. For the best possible
function it is necessary to leave 1-2 mm free space between the pick-up rollers and the paper
stack before closing the sheet feeder.
d) Set the two paper supports close to the margins of the paper.
e) Adjust the two green DOCUMENT GUIDES at the lower part of the front panel so that they
touch about 5 mm of the paper when it leaves the printer. When using a stiff paper, or a paper
with a weight above 150 gram (90lbs) the document guides can be placed beside the paper.
f) Select card or sheet mode on the sheet feeder. CARD mode is normally for paper of 120-200
gsm, and SHEET mode for paper below this weight. Make sure that the CARD/SHEET selection
is set to the same position on both side of the paper.
