Version 03/04
Big Buck Hunter II Page 7
DRILL 1" HOLE
DRILL 3/16" HOLE
(2 PLACES)
START BUTTON
HOLE TEMPLATE
Cabinet Selection
You can choose either a new cabinet or a used
cabinet for your BIG BUCK HUNTER game. Reusing
a cabinet is by far the most cost-effective way to
maximize the return of your initial investment. In
either case, all you need to provide is the cabinet with
a power supply, bill acceptor and monitor. We
provide the rest. The end result is a new game at a
very low cost.
NOTE:
It is recommended that a cabinet used for similar types
of games be used for your BIG BUCK HUNTER. Large
monitors mounted at a right angle work best.
NOTE:
The monitor must be mounted perpendicular to the gun
for the game to play correctly.
When selecting a cabinet, keep this in
mind:
A cabinet with a 25" or larger monitor, mounted at a
right angle, will produce the best game play results.
The monitor must be perpendicular to the gun for the
game to play correctly.
1. Remove the following from the cabinet: Main
Logic Board(s), Control Panel, Monitor Plexiglas,
Marquee, Cabinet Graphics
2. Thoroughly clean out your cabinet. Remove all
the old buttons, joysticks and wires from the
control panel.
DO NOT
remove monitor and
speaker wires.
3. If your cabinet does not have switches or buttons
inside the cabinet, you will need to install them for
volume control and access to diagnostics and
testing modes.
4. Remove the old graphics and adhesive from the
control panel, and the side of the cabinet.
5. For a fresh look, painting is highly recommended.
Spray painting gives a better finish, but if an air
brush or paint sprayer is unavailable, a roller is
second best. Remember to cover all exposed
surfaces not to be painted.
6. The "new game look" should always apply to the
inside of your game as well. A few wire ties and
shrink tubing on your harness, some fastening
hardware on your subassemblies, and a sweep
with the vacuum cleaner will help ensure that
glitches do not occur.
C
ONTROL
P
ANEL
Compare your cabinet’s control panel to the diagram
below to determine how to install the graphics and
controls. The BIG BUCK HUNTER gun holster is
mounted either on the front or side of the cabinet, so
your control panel requires very little drilling.
Button Preparation
Big Buck Hunter comes with an illuminated Start
button. When making the hole for the Start button,
use the control panel layout diagram as a guide to
where you should drill your new hole, and mark the
center of the hole with a pencil.
Locate and Mark the center of the control panel.
Position and attach the Start Button Hole Pattern
Template to your control panel. Be sure that the
location you have selected is free from obstructions
inside the cabinet. Be sure that the template is
oriented correctly.
Carefully drill and deburr the 1” center hole, and the
two 3/16” mounting holes.
Use a file to smooth any rough edges on the holes.
Fill any old and unused holes with wood, resin, or a
metal plate.
It is recommended that you cover your control panel
with Plexiglas. Now would be a good time to cut it to
fit while the dimensions and tools are at hand.
Install the control panel graphics and labels, following
the instructions found in the manual. Cut away any
graphics material from the button holes.
