Big Buck Hunter II Page 6
Version 03/04
K
IT
G
AME
I
NSTALLATION
K
IT
P
ACKAGE
C
ONTENTS
(1) Printed Circuit Board (PCB) Assembly
(1) Hard Drive and 40-Pin Ribbon Cable
(1) ATX Power Supply
(1) Gun Assembly
(2) Gun Mounting Clips
(1) Illuminated Button Assembly
(1) Card Reader Assembly
(1) Misc. Mounting Hardware
(1) Marquee Styrene
(1) Control Panel Overlay
(1) Set Control Panel Labels
(2) Side Decals
(1) Set Installation Templates
(1) 50 ft. Telephone Cable
(1) Telephone Line Splitter
(1) Manual
R
ECOMMENDED
T
OOLS AND
S
UPPLIES
•
Phillips and Slotted Screwdrivers
•
Socket Set, Wire Cutters and Strippers
•
Pliers or Channel Locks
•
Electric Drill with 3/32", ¼", and 7/16" Bits
•
Chassis or Sheet Metal Punch
•
Razor Knife and Sharp Blades
•
Soldering Iron and 60/40 Resin Core Solder
•
Assorted Fastening Hardware
•
Heat Shrink Tubing (3/32", 1/8", and 3/16")
•
Masking Tape or 4" Wire Ties
IF YOU DO YOUR OWN PAINTING, YOU'LL NEED
THESE PAINT SUPPLIES:
•
Air Brush or Paint Sprayer
•
Paint Brush, Paint Roller and Pan
•
Paint (and Primer)
•
Sandpaper
I
NSTALLATION
P
REPARATION
BEFORE YOU START.....
1. Checks to see if all the needed parts have been
included in your kit or tournament cabinet.
2. Do you have the necessary tools?
3. Do not work with any part of the system plugged
in (lights, monitor, or power supply).
T
HE
C
ABINET
Power Requirements
WARNING!
ATX Power Supplies require a load to operate. There
will be no Voltage Output if the power supply is not
connected to the main board.
Big Buck Hunter II requires an ATX Power Supply,
supplied with this kit. Make sure the game you have
chosen to convert is able to supply all the required
voltages for Big Buck Hunter II.
+5 VDC 15 amps
+12 VDC 3 amps
WARNING!!!
The output level of many “regulated” switching power
supplies actually varies with load. For this reason, the
power supply from an old game may not be correctly
adjusted for BIG BUCK HUNTER II. This makes the
existing power supply inappropriate and hazardous to
your new game. Measure power on the PCB, on the
Boot ROM U15. Damage will occur if the power supply
is outside the acceptable limits (between 5.0 and 5.15
VDC.)
Monitor Requirements
BIG BUCK HUNTER II requires a monitor in a
horizontal mount raster scan with negative composite
SYNC. It can be difficult to change the monitor from
vertical to a horizontal unit. Therefore, installation will
be easier if you choose a horizontal mount cabinet.
BIG BUCK HUNTER II has been designed for
medium-resolution monitors
. For best results,
choose a cabinet with a mid-res monitor. Consult your
monitor for mid-res adjustment.
If you have a lo-res monitor, Big Buck Hunter II will
work with the addition of a special Monitor Scaler
Board. Check with your distributor for more details.
CAUTION
! Monitors are extremely dangerous and
can result in severe injury. Make sure you follow and
observe all safety precautions as outlined in your
monitor’s manual.
