Version 03/04
Big Buck Hunter II Page 27
CARD READER
tests the card reader hardware. After
pressing the START button, you will see the message
“NO DATA DETECTED YET”. Insert a card into the
card reader. Normally the message “A CARD SWIPE
HAS BEEN DETECTED.” is displayed, as well as the
recognized card type. If you do not get the “A CARD
SWIPE H
AS BEEN DETECTED” message try inserting
a card at different speeds or use a different card. If still
unsuccessful, contact your distributor or the IT service
department.
COMMUNICATION TESTS
This menu is designed to help test the ways the board
can communicate with ITNet.
MODEM
tests the existence of the modem as well as its
ability to respond. Each machine needs its own
working modem, even if daisy chained. Pressing the
START button when MODEM is selected will activate
the test and a pass or fail message will appear. If the
modem test fails, contact your distributor or the IT
Service Department.
ETHERNET
tests for existence and response of your
Ethernet controller. This feature is not currently being
utilized by ITNet.
MOTHERBOARD TESTS
This menu is to help test some of the basic hardware
located in your Big Buck Hunter II machine.
BOOT ROM
tests the memory your game boots from.
To activate this test press the START button. You will
get one of two messages: “BOOT ROM CHECKSUM IS
CORRECT” or “BOOT ROM CHECKSUM IS
INCORRECT”. If you get the failure message please
contact your local distributor or the IT Service
Department.
VOLTAGE ADJUSTMENT
(GREEN BOARDS ONLY)
tests the voltage levels of the game’s power supply.
This test reveals one of four messages the instant the
menu selection is highlighted. “VOLTAGE IS WITHIN
ACCEPTABLE RANGE” means that everything is
working properly. “VOLTAGE IS HIGH” or “VOLTAGE
IS LOW” means you have to adjust the voltage until you
get the ACCEPTABLE RANGE message. “VOLTAGE
DETECTION FAILURE” means there is a hardware
failure with the voltage detect circuitry and you should
contact your local distributor or the Incredible
Technologies Service Department.
REALTIME CLOCK
is used to display the board’s clock
in current local time. Pressing the START button will
display the current local time and date. If the time is
incorrect it can be adjusted by making a call to ITNet.
NVRAM
tests the non-volatile RAM, or memory, on the
game’s board. Pressing the START button will activate
this test. You will get one of two messages: NVRAM
CHECKSUM SUCCEEDED or NVRAM CHECKSUM
FAILED. As with all other tests if you get the failure
message contact your local distributor or the Incredible
Technologies Service department.
MECHANICAL METER TEST
tests the hard meter in
your cabinet. Press the trigger to increment the meter
by 1 pulse.
GUN CALIBRATION RESULTS\INPUT
TESTS
Gun Calibration
is used to measure the sighting and
accuracy of the gun.
Use this test to verify the degree of accuracy of the
gun’s sighting, in relation to the screen. Stand
approximately 3 feet away from the cabinet and aim the
gun at the center of the screen. The red dot will move
with the gun, and you should be able to aim it
accurately in the bullseye target on the screen.
If your aiming seems off, you can calibrate your gun for
better accuracy in the Gun Calibration Menu, accessed
from the Main Menu.
