IMO Jaguar CUB, Инструкция по эксплуатации, Страница: 51 / 170

3-9
If you press the or key in any conditions other than those described above, the following will
appear:
Frequency
command 1
(F01)
Frequency
setting from
communica-
tions link
Multistep fre-
quency setting
PID control can-
celled
Displayed using or key
PID enabled
0 Disabled Disabled
Cancelled
Frequency setting by keypad
PID enabled
PID output (as final frequency set-
ting)
Other than the above
Cancelled
Manual speed command currently
selected (frequency setting)
(3) Monitor the Running Status
In Running mode, the seven items listed below can be monitored. Immediately after the inverter is
turned on, the monitor item specified by function code E43 is displayed. Press the
key to switch
between monitor items.
Table 3.3 Monitor Items
Monitor Items
Display Sample on
the LED monitor
Meaning of Displayed Value
Speed monitor
(Hz, rpm, m/min, min)
50.00
Refer to Table 3.4.
Output current (A)
1.90A
Detected output current.
A
: An alternative expression for A (ampere)
Input power (kW)
0.40P
Detected input current to the inverter in Amp.
P : An alternative expression for kW (kilo watt)
Output voltage (V)
200U
Commanded output voltage.
U
: An alternative expression for V (voltage)
PID process command (Note 1)
10.00.
(Note 2)
PID feedback amount (Note 1)
9.00.
(Note 3)
(PID process command or PID feedback
amount)
u
(PID display coefficient A – B) + B
PID display coefficients A and B: Refer to
function codes E40 and E41
Timer (sec) (Note 1)
6
(Note 4) Remaining effective timer count
(Note 1) The PID process command and PID feedback amount are displayed only under the PID
control using a process command (J01 = 1 or 2). Further, the timer (for timer operation) is
only displayed when timer is enabled (C21 = 1).
(Note 2) The dot in the lowest digit will blink.
(Note 3) The dot in the lowest digit will light.
(Note 4) A positive integer is displayed.