IMO Jaguar CUB, Инструкция по эксплуатации

Страница: 145 / 170

8-1
Chapter 8 SPECIFICATIONS
8.1 Standard Models
8.1.1 Three-phase 200 V Series
*1 4-pole standard
*2 The rated capacity is for 220V output voltage.
*3 Output voltages cannot exceed the power supply voltage.
*4 Use the inverter at the current given in ( ) or below when the carrier frequency command is higher than 4
kHz ( F 26 = 4 to 15 ) or the ambient temperature is 40
q
C or higher.
*5
(5.2.3)) 3 - 61800 IEC to (Refer 67
(V) voltage average phase - 3
(V) e Min.voltag - (V) e Max.voltag
= (%) unbalance voltage Interphase
u
If this value is 2 to 3 %, use an AC reactor (ACR).
*6 Tested under the standard load condition (85% load for applicable motor rating).
*7 Calculated under specified conditions.
*8 Indicates the value when using a DC reactor (option).
*9 Average braking torque obtained with the AVR control off (
F 05 = 0 ). (Varies according to the efficiency
of the motor.)
*10 Average braking torque obtained by use of an external braking resistor (standard type available as
option).
*11 To make Jaguar CUB compliant with category TYPE1 of the UL Standard, Note that the
TYPE1-compliant Jaguar CUB should be used in the ambient temperature range from -10 to +40
q
C.
Note: A box (
†
) in the above table replaces the E suffix for filtered version.