6
INS
TALL
AT
O
RE
U
TENTE
MANU
TENT
O
RE
1
OK
1
INSTALLATION.
1.1 DESCRIPTION OF THE PRODUCT.
Victrix Hybrid is a hybrid heat pump consisting of:
- Victrix 24 HY Hybrid Indoor Unit;
- Outdoor Unit Audax.DK4.
- control panel (supplied in the accessories group of the indoor
unit)
The Victrix Hybrid heat pump was designed only for heating and
production of domestic hot water for domestic use and similar
purposes.
In order to operate properly, the Victrix 24 HY indoor unit must
be paired with an Audax DK4 outdoor unit; as such, all the pro-
visions regarding the safety and use of the control panel, indoor
and outdoor units must be respected.
1.2 INDOOR UNIT INSTALLATION
RECOMMENDATIONS.
ATTENTION:
operators who install and service the
appliance must wear the personal
protective equipment required by ap-
plicable law.
The Victrix 24HY indoor unit was designed only for
wall-mounted installation.
The place of installation of the indoor unit and relative
Immergas accessories must have suitable features
(technical and structural), such as to allow for (al-
ways in safe, efficient and comfortable conditions):
- installation (according to the provisions of technical legisla-
tion and technical regulations);
- maintenance operations (including scheduled, periodic,
routine, special);
- removal (to outdoors in the place for loading and transport-
ing the appliances and components) as well as the eventual
replacement of those with appliances and/or equivalent
components.
The wall surface must be smooth, without any protrusions or
recesses enabling access to the rear part. They are not designed
to be installed on plinths or floors (Fig. 1).
By varying the type of installation the classification of the boiler
also varies, precisely:
-
Type B
23
or B
53
if installed using the relevant terminal for air
intake directly from the room in which the indoor unit has
been installed.
-
Type C
if installed using concentric pipes or other types of
pipes envisioned for the sealed chamber indoor units for
intake of air and expulsion of flue gas.
Note:
the classification of the indoor unit is provided in the
depictions of the various installation solutions shown on the
following pages.
Only professionally enabled companies are authorised to install
Immergas gas appliances.
Installation must be carried out according to regulation stand-
ards, current legislation and in compliance with local technical
regulations and the required technical procedure
ATTENTION:
It is forbidden to install appliances
removed from other systems. The ma-
nufacturer declines all liability in the event of
damage caused by appliances removed from
other systems or for any non-conformities with
such equipment.
ATTENTION:
check the environmental operating
conditions of all parts relevant to in-
stallation, referring to the values shown in the
technical data table in this booklet.
