Instructions for Use and Guarantee Conditions
14
IML
-Instrumenta Mechanik Labor System GmbH
I
Parkstraße 33
I
69168 Wiesloch I
Phone +49 (0) 6222 6797-0
I
Fax +49 (0) 6222 6797-10
I
E-mail [email protected]
I
Web: www.iml.de
ENGLISH
Instruction
Replacing the safety pin
Insert the hexagon bolt into the drive shaft, ensuring that the markings of the
drive shaft and of the hexagon bolt coincide. Now drive in the new safety pin by
means of a hammer. Re-attach the drill as described on page 19.
Overload clutch
The overload clutch is worn out, if:
-
the slide with the recording needle does not move from the rear position!
-
the recording needle does not move forward at uniform speed!
Tools:
Adjusting wrench, sickle spanner,
counter wrench, screwdriver,
hexagon socket screw key
Adjusting the overload clutch by means of the sickle spanner
-
if the slide is in rear position, move it forward by 2 to 3 mm
-
remove the storage battery for safety reasons
-
remove the clutch cap
-
fix the adjusting nut by means of the sickle spanner and loosen the counter nut
by means of the counter wrench and turn it out a little
-
loosen the adjusting nut
-
insert the small hexagon socket screw key into the slot on the one side of the
adjusting nut and turn it slowly (1/8 rotations) by means of the sickle spanner
-
stop the spindle by means of the screwdriver and tighten the adjusting nut
-
fix the adjusting nut by means of the sickle spanner and firmly tighten the counter
nut by means of the counter wrench!
Safety pin
Pin punch
Attachment
Safety
pin
Markings
Attachment
Drive shaft and
hexagon bolt
Clutch disks
Counter wrench
& screw driver
Hex. socket
screw key
