Imagine Selenio X100, Инструкция по установке и эксплуатации

Страница: 131 / 178

Selenio X100
Installation and Operation Manual
119
Loudness Control Parameters
Table 4-10. DTS Neural Audio Loudness Control Parameters
Parameter Name Function Options
Loudness Control Function Enables the Loudness Control feature

Enable

Disable
Loudness Control Status Indicates the state of the AAP mode

Uninitialized

Running

Not Running (bypassed)

Not Running
Target Loudness Level Specifies the loudness level that will be targeted
-40 dBEq to 0 dBEq
(
-27 dBEq )
LC Ratio Controls the amount of gain or attenuation that is
applied when loudness differences are measured 0% to 100% ( 90% )
Upper Threshold Specifies the highest measured loudness of the
input that will be permitted before attenuation is
applied 0 dB to 20 dB
Lower Threshold Specifies the lowest measured loudness of the input
that will be permitted before gain is applied -20 dB to 0 dB
Freeze Window Specifies the size of a window in which small
loudness differences are allowed without the need
to change gain or attenuation
0.0 dB to 10.0 dB ( 1.0 dB )
Quiet Threshold Controls the noise floor level
-80 dBEq to -20 dBEq
(
-50 dBEq )
Attack Time Controls how quickly the processing will respond to
sharp increases in loudness
5 ms to 150 ms ( 20 ms )
Release Time Controls how quickly the processing will respond to
sharp decreases in loudness
20 ms to 500 ms ( 120 ms )
Compressor Threshold Controls the amount of attenuation applied when
short-term peaks exceed the compressor threshold 0 dB to 16 dB ( 5 dB )
Compressor Ratio Controls the amount of attenuation applied when
short-term peaks exceed the compressor threshold
0% to 100% ( 40% )
Loudness Shaping Specifies the amount of loudness shaping desired
0.0 to 1.0 ( 0.5 )
Final Limiter Ceiling Specifies the threshold above which final limiting
will be applied
-20 dBFS to 0 dBFS ( 0 dBFS )
Metering Activates the real-time meter.

Off

On
Current Input Loudness
[RO] Reports the smoothed input loudness measurement -60 dBEq to 20 dBEq
( 0 dBEq )
Current Input Peak [RO] Reports the input peak measurement
-60 dBFS to 20 dBFS ( 0 dBFS )
Current Output Loudness
[RO] Reports the smoothed output loudness
measurement
-60 dBEq to 20 dBEq
(
0 dBEq )
Current Output Peak [RO] Reports the output peak measurement
-60 dBFS to 20 dBFS ( 0 dBFS )
Current Correction [RO] Reports the amount of correction being applied
-60 dB to 60 dB ( 0 dB )
Current Compression [RO] Reports the amount of compression being applied
-60 dB to 60 dB ( 0 dB )